![]() The above table can be added to the Group Policies by the following powershell commands (administrator account access right required): In the Windows 8, Server 2012, Windows 10 and later it is possible to use PowerShell to configure the values with the NetQosPolicy Cmdlet. You may change this values to meet requirements on your traffic prioritisation and routing equipment. The DSCP Values in the above example are default DSCP values used by innovaphone devices, according to the Wiki article Howto:Calculate Values for Type of Service (ToS) from DiffServ or DSCP Values. ![]() Innovaphone SoftwarePhone Signalling SIPS Innovaphone SoftwarePhone Signalling H323/TLS Innovaphone SoftwarePhone Signalling H323/TCP Innovaphone SoftwarePhone Signalling H225 %programfiles(x86)%\innovaphone\SoftwarePhone\softwarephone.exe %programfiles(x86)%\innovaphone\myApps\myApps.exe %programfiles(x86)%\innovaphone\myPBX\myPBX.exe Microsoft Windows QoS Policy Mappings for innovaphone Applications This could be done for a single computer or distributed to a number of computers via the domain controller. Usually the configuration of the Policy-based Quality of Service is done by defining a Group Policy Object (GPO) in the Group Policy Management Console (GPMC). Instead to set the ToS Value in the Application the Policy-based Quality of Service (QoS) provided by the MS Windows operating system can be used to mark the IP packets. In contrast to the innovaphone devices, that allows you to specify the IP v4 TOS header field value used for voice and signalling IP packets, the MS Windows based applications like SoftwarePhone, myPBX or myApps do not have any possibility to set ToS Values on the RTP packets due to restriction of the Microsoft Windows operating system. This information applies to all innovaphone Windows Applications sending the RTP Data (this is currently the SoftwarePhone (audio), myPBX launcher (video) and myApps (audio, video))
0 Comments
Leave a Reply. |